Bissell 5288 - Manual (Page 6)

16
w w w . b i s s e l l . c o m
Charging the battery (Continued)
4. To charge your Flip-Ease, connect the round
end of the charger cord into the charging
port on the side of the unit. Make sure it
is securely connected and the charger
indicator light is illuminated.
NOTE: Decreased operating time may
indicate that the battery has built up a
charging resistance. To recharge, first
completely exhaust the battery, recharge it,
then exhaust it once again before recharging a
second time. This procedure may be required
more than once.
Filling the clean tank
1. Remove clean tank by grasping it firmly and
pulling straight up.
2. Unscrew the black cap on the bottom of the
clean tank and remove the insert.
3. Add water and formula* to the indicated fill
lines on the clean tank.
*Note: Your Flip-Ease includes two trial size
bottles of formula.
4. Replace the black cap and insert and place
clean tank back on unit.
Dry vac
1. Attach the MicroFiber pad onto the base of
the unit by attaching the pad onto the velcro
on one side of the unit, wrapping it under
the foot and attaching it to the velcro on the
opposite side.
Note: If the MicroFiber pad covers the vacuum
suction path, the unit will not suction.
2. Turn the power switch " I " (ON).
3. With the dry vac side of the unit facing forward,
begin cleaning. You will see dry dirt, crumbs and
debris being collected in the dirty tank.
O
perations (Continued)
6
w w w . b i s s e l l . c o m
2
1 1a
Tip:
The MicroFiber pad should be
placed on the unit as directed.
Covering the vacuum suction path
will stop all suction.
Underside of foot
MicroFiber Pad
Suction Path
Tip:
The battery is
used only when
dry vacuuming.
For wet mopping,
the battery is not
used, extending
usage time.
3
FORMULA
WATER
Tip:
Gently push the
tank into place. If
you see air
bubbles in the
tank, it is
seated properly.
2
4
Charging
Port
ug603-6913_5288E_1006.indd 6 ug603-6913_5288E_1006.indd 6 10/25/06 3:49:08 PM 10/25/06 3:49:08 PM