Toshiba Portege A600 - Manual (Page 184)

User’s Manual C-3
Wireless LAN
*1 Factory-set default channels
*2 The band width and the channel which can be used depends on the
installed wireless LAN module. And the approved channels on using are
different at each country or region. The channel configuration is managed
as follows:
■ For wireless clients that operate in a Wireless LAN Infrastructure, the
Wireless LAN module will automatically start operation at the channel
identified by the Wireless LAN Access Point. When roaming between
different access points the station can dynamically switch to another
channel if required.
■ In a Wireless LAN Access Point, the Wireless LAN module will use the
factory-set default channel (printed in bold), unless the LAN
Administrator selected a different channel when configuring the
Wireless LAN Access Point device.
■ For Wireless LAN module installed in wireless clients that operating in a
peer-to-peer mode, the card will use the default channel 10.
5 GHz Band Channels Sets (Wireless IEEE 802.11 Revision a and
n draft 2.0)
Frequency Range
Channel ID
5150-5850 MHz
36 5180*
1
40 5200* 1
44 5220*
1
48 5240*
1
52 5260* 1
56 5280* 1
60 5300*
1
64 5320*
1
100 5500* 1
104 5520* 1
108 5540*
1
112 5560*
1
116 5580* 1
120 5600* 1
124 5620*
1
128 5640* 1
132 5660* 1
136 5680*
1
140 5700*
1