Retaining data with power off, Extending battery life, Replacing the battery pack – Toshiba Libretto W100 User Manual
Page 73
User’s Manual
5-7
Power and Power-Up Modes
Retaining data with power off
Refer to User Information Guide about Retaining time.
Extending battery life
To maximize the life of your battery packs:
■
At least once a month, disconnect the computer from a power source
and operate it on battery power until the battery pack fully discharges.
Before doing so, follow the steps as detailed below.
■
If you have extra battery packs, rotate their use.
■
If you will not be using the system for an extended period, for example
for more than one month, remove the battery pack from the computer.
■
Store spare battery packs in a cool dry place out of direct sunlight.
Replacing the battery pack
Please be aware that the battery pack is classified as a consumable item.
The operating life of the battery pack will gradually reduce through
repeated charging and discharging, and will need to be replaced when it
reaches the end of its operating life. In addition to this, you might also
replace a discharged battery pack with a charged spare when you are
operating your computer away from an AC power source for an extended
period of time.
This section explains how to remove and install the battery pack, and
begins with the removal process which is detailed through the following
steps.
1. Turn off the computer's power.
2. Disconnect the AC adaptor and turn on the computer's power - if it
does not turn on then go to Step 4.
3. Operate the computer on battery power for five minutes. If you find
that the battery pack has at least five minutes of operating time,
continue operating until the battery pack is fully discharged,
however, if the DC IN/Battery indicator flashes or there is some
other warning to indicate a low battery condition, go to Step 4.
4. Connect the AC adaptor to the DC IN 19V jack of the computer,
and to a wall outlet that is supplying power. The DC IN/Battery
indicator should glow amber to indicate that the battery pack is
being charged, however, in the event that DC IN/Battery indicator
does not glow this indicates that power is not being supplied -
check the connections for the AC adaptor and the power cord.
5. Charge the battery pack until the DC IN/Battery indicator glows
green.