Toshiba L1433 - Manual (Page 15)

English - 14 -
English
Initial Installation
Before switching on the TV, put your decoder and media recorder to
Standby if they are connected and
ensure the aerial is connected to your TV. To set up the TV, use the buttons on the remote control as
detailed on page 8.
IMPORTANT: Ensure that the aerial is connected and
a Common Interface module is not inserted before
switching on the TV for the first time installation.
1. Connect the mains plug and switch the TV on
using the / I button. If the TV does not switch on,
press any numbered or button on the remote
control, then the language selection menu will
be displayed. This screen will appear the first
time that the TV is switched on and each time
the TV is reset.
2. By pressing Up or Down button, highlight the
language you want to set and press
OK button.
The following screen will be displayed next:
3. By pressing Left or Right button, select the
country you want to set and press Down button
to highlight the
Search Type option. Use Left or
Right to set the desired search type. Available
search types are digital only, analogue TV only
and full.
4. When set, press Down button to highlight
Teletext Language. Use
Left or Right button to
select desired language region. Highlight
Scan
Encryted Channels and enable/disable this
option by using
Left or Right buttons.
5. Press OK button on the remote control to continue
and the following message will be displayed on
the screen:
Select Store mode if the TV will be placed in a
store to exhibit. This option will configure your
TV’s settings for best display quality and the
supported features of the TV will be displayed on
the top of the screen as a info banner. If
Store
mode is selected, a confirmation screen will be
displayed. Select
YES to proceed. This option will
be available in
Other Settings menu and can be
turned off/on later.
If Home Mode is selected, Store Mode will not
be available after the
First Time Installation. For
home use select
Home Mode.
6. Press OK button on the remote control to continue
and the following message will be displayed on
the screen:
7. Select Yes button by using Left or Right button
and press
OK button to continue. Afterwards, the
following OSD will be displayed on the screen:
8. If you select Cable option, a confirmation screen
will be displayed. Select YES to proceed. The
following screen will be displayed:
Note: Although this cable feature can be selected,
it is not fully supported in the UK. If cable signals
are input to this TV from a Cable Network Provider
some may be displayed.