Toshiba L1433 - Manual (Page 29)

English - 28 -
English
Settings Menu Operation, Conditional Access
Configuring Your TV’s Settings
Detailed settings can be configured to suit your
personal preferences.
Viewing Settings Menu
Press
MENU button and select Settings by using Left
or
Right button. Press OK button to view Settings
menu.
Operating Settings Menu Items
• Press Up or Down button to highlight a menu item.
• Press OK button to select an item.
• Press MENU button to exit.
Conditional Access
This setting controls conditional access modules
when available. Use
Up or Down button to highlight
Conditional Access. Press OK button to continue.
Language
Configures language settings. See page 21.
Parental
Configures parental settings. See page 22.
Timers
Sets timers for selected programmes. See page 29.
Date/Time
You can configure date/time preferences by using this
menu screen. See page 29.
Sources
Enables or disables selected source options. See
page 30.
Other Settings
Displays other setting options of the TV set.
Using a Conditional Access Module
The Common Interface Slot, situated on the side of the
television, enables the insertion of a CAM (Conditional
Access Module) and card. These are purchased from
a service provider and allow additional subscription
broadcasts to be viewed. For more information, see
a service provider.
IMPORTANT: Insert or remove the CAM only when
the TV is SWITCHED OFF.
• In order to watch certain digital channels, a conditional
access module (CAM) is necessary. This module must
be inserted in the CI slot of your TV.
• Obtain the Conditional Access Module (CAM) and
the viewing card by subscribing to a pay channel
company, then insert those to the TV using the following
procedure.
• Insert the CAM and then the viewing card to the slot that
is located in the terminal cover at the rear side of the TV.
• The CAM should be correctly inserted, it is impossible
to insert fully if reversed. The CAM or the TV terminal
may be damaged if the CAM is forcefully inserted.
Connect the TV to the mains supply, switch on and then
wait for few moments until the card is activated.
• When no module is inserted, “ No common interface
module detected.” message appears on the screen.
• Refer to the module instruction manual for details of
the settings.
Viewing Conditional Access Menu (*)
(*) These menu settings may change depending on
the service provider.
Press
MENU button and select Settings by using Left
or
Right button. Press OK button to view Settings
menu. Use
Up or Down button to highlight Conditional
Access and press OK to view menu items.