Toshiba Satellite P100 (PSPAD) - Manual (Page 99)

User’s Manual 6-13
Power and Power-Up Modes
Starting the computer by password
If you registered a password, start the computer by entering the password
manually.
To enter a password manually, follow these steps:
1. Turn on the power. The following message will appear:
Enter Password [xxxxxxxx]
2. Enter the Password.
3. Press Enter.
Power-up modes
The computer has three power-up modes:
■ Hibernation (saves data in memory to the hard disk)
■ Sleep Mode (Power remains on, saving data in RAM, but the CPU and
all other devices enter sleep mode.)
■ Boot (does not save data in memory)
Panel power off/on
In AC mode, this feature turns power to the computer off when the display
panel is closed and turns it back on when the panel is opened.
In Battery mode, the Hibernation feature turns power to the computer off
when the display panel is closed and cannot turn it back on when the panel
is opened. The Sleep Mode turns power to the computer off when the
display panel is closed and turns it back on when the panel is opened.
The password is necessary only if the computer was shut down in boot
mode, not in Hibernation or Sleep Mode.
If you enter the password incorrectly three consecutive times, the
computer shuts down. You must turn on the computer again and re-enter
the password.
Refer also to the section Turning off the power in Chapter 3, Getting
Started .
If the panel power off function is enabled and you use Shut down
Windows, do not close the display until the shut down function is
completed.