Toshiba Qosmio F30 (PQF32) - Manual (Page 135)

User’s Manual 7-5
HW Setup
HDD Priority Options
This option lets you set the priority for HDD detection. If the first detected
HDD has a boot command, the system will boot from the HDD.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE] Sets PXE as the protocol (Default).
[RPL] Sets RPL as the protocol.
Keyboard
Wake-up on Keyboard
When this feature is enabled and the computer is in Standby mode, you
can turn on the computer by pressing any key. It is effective only for the
internal keyboard and only when the computer is in standby mode.
Built-in HDD1 −>
Built-in HDD2
(Default)
The computer will look for the Built-in HDD1 first,
next the Built-in HDD2 (Default).
Built-in HDD2 −>
Built-in HDD1
The computer will look for the Built-in HDD2 first,
next the Built-in HDD1.
■ If a boot command is not found on the first detected HDD, the system
will not boot from the other HDD. It will search the next device in the
boot priority for a boot command.
■ Although, generally, most models have two hard disks installed, some
models have only one hard disk. In the case of models with one hard
disk, this setting item will not be displayed.
Enabled Enables the Wake-up on Keyboard function.
Disabled Disables the Wake-up on Keyboard function
(Default).