Toshiba Tecra M4 - Manual (Page 89)

TECRA M4 4-17
Operating Basics
2. Grasp the disc tray gently and pull until it is fully opened.
Pulling the disc tray open
3. Lay the CD/DVD, label side up, in the disc tray.
Inserting a CD/DVD
4. Press gently at the center of the CD/DVD until you feel it click into
place. The CD/DVD should lie below the top of the spindle, flush with
the spindle base.
Disc tray
Laser lens
When the disc tray is fully opened, the edge of the computer will extend
slightly over the CD/DVD tray. Therefore, you will need to turn the CD/DVD
at an angle when you place it in the disc tray. After seating the CD/DVD,
however, make sure it lies flat.
■ Do not touch a laser lens and its circumference portion. Doing so could
cause misalignment.
■ Prevent foreign objects from entering the drive. Check the surface of
the disc tray, especially the area behind the front edge of the disc tray,
to make sure there are no such objects before closing the drive.
■ Never use a cracked, deformed or repaired CD or DVD. Fragments
from a damaged CD or DVD could cause injury.