Toshiba AT300 - Manual (Page 20)

Using the tablet for the first time
This section provides basic information about how to start using your tablet.
It covers below steps followed by the details.
Connecting the AC adaptor
Turning on the power
Initial Setup
Turning off the power
Use a virus-check program and make sure it is updated regularly.
Never format storage media without checking its content - formatting
destroys all stored data.
It is a good idea to periodically backup internal storage of the tablet to
an external media. General storage media is not durable or stable
over long periods of time and under certain conditions may result in
data loss.
Connecting the AC adaptor
When battery power becomes low, you must charge it.
Use only the tablet connected to an AC power source or TOSHIBA Tablet
Dock to charge the battery. Never attempt to charge the battery with any
other charger.
The AC adaptor can automatically adjust to any voltage ranging from 100
to 240 volt and to a frequency of either 50 or 60 hertz, enabling you to use
this product in almost any country/region. The adaptor converts AC power
to DC power and reduces the voltage supplied to this tablet.
Figure 3-2 The AC adaptor & power cable
3
4
1
2
2-pin
3-pin
1. AC adaptor 2. Power cable
3. Power connector 4. USB connector
Depending on the model, either a 2-pin or 3-pin AC adaptor will be
bundled with the tablet.
User's Manual 3-7