Bissell PROHEAT PRO-TECH 7920 - Manual (Page 20)

B issell PowerSteamer® ProHeat™ Series Service Center Repair Guide
Printed February, 2001
1/30/2004 (Revision 1) 19
Lower Handle Disassembly
1. Remove the two screws located near the bottom of the tool caddy on the back of the
machine.
2. Remove the two bolts and nuts that go through the upper part of the tool caddy and
handle assembly.
3. Lift upper handle off lower handle assembly.
4. Remove two screws from the back of lower handle assembly.
5. Recline the handle backwards fully.
6. Lift lower handle front free by pulling up on the tabs near the top.
7. Disconnect all wire connections from light. There will be one black wire and up to two
white wires (one from the Perfect Pass™ housing and one from the heater) connected to
the light.
Bolts and Nuts (2ea.)
Screws (2)
Screws (2)