Nokia E90 Communicator - Manual (Page 56)

To divert calls to another phone number, select a call type and a diverting option, then select Options > Activate > Diverted
to: . Enter a number in the Number: field, or select Find to retrieve a number saved in Contacts.
Call barring
Select > Tools > Settings > Phone > Call barring .
You can bar the calls that can be made or received with the device (network service). To change the settings, you need the
barring password from your service provider. Call barring affects all calls, including data calls.
Call barring and call diverting cannot be active at the same time.
When calls are barred, calls may be possible to certain official emergency numbers.
To bar calls, select
Voice call barring and select from the following options:
• Outgoing calls — Prevent making voice calls with your device.
• Incoming calls — Bar incoming calls.
• International calls — Prevent calling to foreign countries or regions.
• Incoming calls when abroad — Bar incoming calls when outside your home country.
• International calls except to home country — Prevent calls to foreign countries or regions, but allow calls to your home
country.
To check the status of voice call barrings, select the barring option, and select Options > Check status .
To stop all voice call barrings, select a barring option, and select Options > Cancel all barrings .
Net call barring
To bar net calls, select > Tools > Settings > Call barring > Internet call barring .
To reject net calls from anonymous callers, select Anonymous call barring > On .
Change the barring password
To change the password used for barring voice, fax, and data calls, select > Tools > Settings > Call barring > Voice call
barring > Options > Edit barring password . Enter the current code, then the new code twice. The barring password must be
four digits long. For details, contact your service provider.
Send DTMF tones
You can send dual tone multi-frequency (DTMF) tones during an active call to control your voice mailbox or other automated
phone services.
Send a DTMF tone sequence
1. Make a call, and wait until the other end answers.
2. Select >
Options > Send DTMF .
3. Enter the DTMF tone sequence, or select a predefined sequence.
Attach a DTMF tone sequence to a contact card
1. Select >
Contacts . Open a contact, and select Options > Edit > Options > Add detail > DTMF .
2. Enter the tone sequence. To insert a pause of about 2 seconds before or between DTMF tones, enter p. To set the device to
send the DTMF tones only after you select Send DTMF during a call, enter w.
3. Select Done .
Voice mail
Select > Tools > Call mailbox .
When you open the Voice mail application for the first time, you are asked to enter the number of your voice mailbox. To change
the number, select Options > Change number .
To call your voice mail, select Options > Call voice mailbox .
To call your voice mailbox in the standby mode, press and hold 1; or press 1 and then the call key.
T e l e p h o n e
© 2007 Nokia. All rights reserved. 24