Nokia N95 - Manual (Page 13)

Tip: To check the software version in your device,
enter *#0000# in the standby mode.
Settings
Your device normally has MMS, GPRS, streaming, and
mobile internet settings automatically configured in
the device, based upon your network service provider
information. You may have settings from your service
providers already installed in your device, or you may
receive or request the settings from the network
service providers as a special message.
You can change the general settings in your device,
such as language, standby mode, display, and keypad
lock settings. See "General settings", p. 93.
Access codes
If you forget any of the access codes, contact your
service provider.
● Personal identification number (PIN) code — This
code protects your SIM card against unauthorised
use. The PIN code (4 to 8 digits) is usually supplied
with the SIM card. After three consecutive incorrect
PIN code entries, the code is blocked, and you need
the PUK code to unblock it.
● UPIN code — This code may be supplied with the
USIM card. The USIM card is an enhanced version of
the SIM card and is supported by UMTS mobile
phones.
● PIN2 code — This code (4 to 8 digits) is supplied
with some SIM cards, and is required to access some
functions in your device.
● Lock code (also known as security code) — This code
(5 digits) can be used to lock the device to avoid
unauthorised use. The factory setting for the lock
code is 12345. To avoid unauthorised use of your
device, change the lock code. Keep the new code
secret and in a safe place separate from your device.
Try entering the code only once, if you forget the
code. If the code you entered is not correct, contact
a Nokia Care point or your service provider for
further instructions.
● Personal unblocking key (PUK) code and PUK2
code — These codes (8 digits) are required to
change a blocked PIN code or PIN2 code,
respectively. If the codes are not supplied with the
SIM card, contact the operator whose SIM card is in
your device.
● UPUK code — This code (8 digits) is required to
change a blocked UPIN code. If the code is not
supplied with the USIM card, contact the operator
whose USIM card is in your device.
13
Us
efu
l in
formation