Nokia Wireless Clip-on Headset HS-21W - Manual (Page 14)

T h e A D - 5 B w i r e l e s s a u d i o a d a p t e r
14
■ Accidental disconnection
If the adapter is accidentally disconnected from the Pop-Port connector or the
headset battery runs down during a call, the call is transferred to the phone and
continues normally. The pairing information stays stored in the permanent memory
of the adapter.
If the 32 feet (10 meter) range between the adapter and the headset is exceeded,
or for some other reason the radio connection between the headset and the
adapter is lost, the adapter and the headset try to restore the lost connection for a
short while. If the connection cannot be re-established, the call is transferred to
the phone and continues normally, and the wireless audio adapter returns to the
idle mode.
■ Optimize the adapter use
The following guidelines will help you to use your adapter in an optimal way:
• Set the back light settings of the phone in automatic mode to prevent
unnecessary battery consumption. In most Nokia phones, select Settings >
Accessory settings > Handsfree > Lights > Automatic.
• The internal vibrator of the phone works only when the adapter is in power
saving mode.
• When you use the silent profile in your phone, you are not able to hear the
ringing tone, and you might not notice the call. The automatic answer does not
work when the silent profile is active.
• If you have switched your phone off and you have the adapter attached to it,
the adapter switches to the init mode when you connect the charger to the
phone.