Brother HL-1850 - Manual (Page 48)

44
The Feed function is used to feed out 24 mm of tape.
To feed out 24 mm of tape:
● Hold down c and press _ once. 24 mm of tape is fed out.
To cut the tape:
● Push down on the tape cutter lever.
☞
In order to prevent damaging the tape, do not try to cut it while printing or feeding.
Pushing down on the tape cutter lever too far may break it.
This function can be used to print many copies of the same text while increasing a certain
number after each label is printed. This type of automatic incrementation is very useful when
printing serial number labels, production control labels or other labels requiring ascending
numbers.
To use the Numbering function:
1 Press f, w, h or e until the cursor is positioned below the number that you
wish to increase.
2 Rotate + until 14/18 NUMBER is displayed, and then press + (OR hold down
c and press O once). The message “NUMBER UNTIL” and the selected number
appears in the display.
☞
To cancel the Numbering function at any time, hold down c and press O
(or press just * ).
3 Rotate + (OR press h or e) until the last number that is to be printed is flashing,
or use the number keys to type in the number.
☞
A number lower than the one that was selected cannot be entered.
4 Press + (OR press p or r) to begin printing the labels. The number of each
copy is displayed while it is being printed.
FEED FUNCTION
NUMBERING FUNCTION