Bissell 7920 - Manual (Page 20)

20
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
Troubleshooting
SmartTemp Ready Light does not illuminate.
Possible Causes Remedies
The machine Power Switch is not Switch must be ON to
turned ON. activate the SmartTemp Ready Light.
Reduced spray or no spray
Possible Causes Remedies
Bladder may be empty. Refill bladder with hand hot tap water.
SmartMix Bottle may be empty. Fill with BISSELL Advanced Deep Cleaning
Formula for cleaning or water
if rinsing.
The Filter may be clogged. Clean out Flow Indicator Filter, page 17.
Tanks may not be seated properly. Turn Power Switch OFF; remove &
reseat tanks. Inspect for presence
of seals.
Pump may have lost prime. Turn Power Switch OFF; after 1 minute
turn ON and depress trigger.
The Pump Belt may be broken. Turn Power Switch OFF and unplug
from the outlet. To check if a Pump
Belt has broken, you will need a flat
head screwdriver. Insert the blade end
into the lower slot of the Belt Access
Door to release the lower snap. If
necessary, insert the blade end into
the upper slot to release the upper
snap. Examine the belt for breakage.
You should be able to see the Pump
Belt looped around the motor shaft. If
it is broken or missing, please refer to
Replacement Parts on page 23 before
calling Consumer Services. Complete
installation instructions will
accompany the Replacement Belt.
Insert
Screwdriver
Blade Here
Lift Here
ug310-5815_7920E_604.indd 20 ug310-5815_7920E_604.indd 20 3/29/06 3:39:50 PM 3/29/06 3:39:50 PM