Boss Audio Systems DIGITAL RECORDING STUDIO BR-1600CD - Manual (Page 107)

107
Insert effect parameter functions
Section 2
● When “AW” is selected
The effect will be applied automatically based on the volume of the
performance. Alternatively, it is also possible to apply wah in a
cyclic fashion.
Mode LPF, BPF
Selection for the wah mode.
LPF:
This creates a wah effect over a wide frequency range.
BPF:
This creates a wah effect in a narrow frequency range.
Polarity DOWN, UP
Selection for the direction in which the filter will change in response
to the input.
UP:
The frequency of the filter will rise.
DOWN:
The frequency of the filter will fall.
Sensitivity 0–100
Adjusts the sensitivity of the filter in the direction specified by the
polarity setting. Higher values will result in a stronger response.
When the setting is 0, the strength of the picking will have no effect.
Frequency 0–100
Adjusts the center frequency of the wah effect.
Peak 0–100
Adjusts the way in which the wah effect is applied to the area
around the center frequency. Lower values will produce a wah effect
over a wider area; higher values, a wah effect over a narrower area.
When the setting is 50, a standard wah sound will be produced.
* With a value of “50” a standard wah sound will be produced.
Rate 0–100
Adjusts the frequency of the auto wah.
Depth 0–100
Adjusts the depth of the auto wah effect.
Level 0–100
This parameter adjusts the volume.
■ When algorithm other than “COSM OD
GUITAR AMP” is selected
Wah Type
Selects either touch wah “TOUCH” or pedal wah “PEDAL.”
TOUCH:
The effect will function as a touch wah.
PEDAL:
The effect will function as a pedal wah.
● When “TOUCH” is selected
Polarity UP, DOWN
Selects the direction in which the filter will change in response to input.
UP:
The frequency of the filter will rise.
DOWN:
The frequency of the filter will fall.
Sensitivity 0–100
Adjusts the sensitivity of the filter in the direction specified by the
polarity setting. Higher values will result in a stronger response.
When the setting is 0, the strength of the picking will have no effect.
Frequency 0–100
Adjusts the center frequency of the wah effect.
Peak 0–100
Adjusts the way in which the wah effect applies to the area around
the center frequency. Lower values will produce a wah effect over a
wide area around the center frequency. Higher values will produce a
wah effect in a narrow area around the center frequency. With a
value of “50” a standard wah sound will be produced.
Level 0–100
This parameter adjusts the volume.
● When “PEDAL” is selected
The effect of the wah pedal can be reproduced by operating an
expression pedal.
For a more detailed explanation, see “Using an expression pedal” (p.
84).
Peak 0–100
Adjusts the way in which the wah effect is applied to the area
around the center frequency. Lower values will produce a wah effect
over a wider area; higher values, a wah effect over a narrower area.
When the setting is 50, a standard wah sound will be produced.
Level 0–100
This parameter adjusts the volume.
BR-1600_R_e.book 107 ページ ２００７年１２月６日 木曜日 午前９時５２分