Sharp XE-A102B - Manual (Page 19)

17
EURO Migration Function
Your register can be modified to correspond with each period set for the introduction of EURO, and
in your register each currency is treated as shown on the table below depending on which period
you are in.
Basically your register can be automatically modified to correspond to the introduction of EURO by
executing automatic EURO modification operation shown below in Z/PGM mode. However, there
are several options you must set depending on your need. So, please carefully conduct necessary
settings.
How currencies are treated in your register
Automatic EURO modification operation
Make sure the mode switch is in the Z/PGM position first, (if necessary, enter the secret code and
press
t) and perform the following procedure. Please note that you can perform each
operation only once with the substitution of “A=1”, “A=2” and “A=3”. For example, if you performed
the operation with the substitution of “A=2” first, you cannot perform the operation with the
substitution of “A=1”.
8:S A* S
*A: Enter 1 for the period 1, 2 for the period 2, and 3 for the period 3.
The details of the register system modification are as shown on the following page:
Period 1
After the introduction of
EURO, and before
EURO banknotes and
coins begin to circulate
Exchange key
Domestic currency
Period 2
After EURO banknotes
and coins begin to
circulate, and before
national currency is
withdrawn from
circulation. (Co-
existence of EURO and
national currency)
Domestic currency
Exchange key
Period 3
After the national
currency is withdrawn
from circulation
Domestic currency
Exchange key
EURO
National currency
(DM, F, etc.)
Foreign currency
Currency
A102_01(E) 05.4.18 9:06 AM Page 17