Sharp GX-BT3 - Manual (Page 5)

E-4
Power Source
„ AC power connection
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
„ Bluetooth standby mode
 The first time the unit is plugged in, the unit will enter
the Bluetooth standby mode. Pairing indicator will light
up.
 To cancel the Bluetooth standby mode, press the ECO
MODE button (remote control) during Bluetooth stand-
by mode. The unit will enter the low power consump-
tion mode.
 To return to the Bluetooth standby mode, turn the unit
on and off again.
 During Bluetooth standby mode, the unit will turn on if
Bluetooth connection is established.
MUTE ON/ STAND-BY
TREBLE
AUDIO IN
BASS
PAIRING
VOL
X-BASS
USB BLUETOOTH
DIMMER
RRMCGA342AWSA
ECO MODE
ECO MODE
Wall socket
AC 100 - 240 V ~
50/60 Hz
„ Battery installation
1 While pushing the locking tab towards the centre of
the remote control, slide out the battery holder.
Back of remote
control
Locking tab
2 Remove the old battery from the battery holder, insert
the new battery and then slide the battery holder back
into the remote control.
Positive (+)
side up
Battery holder
Polarity (+)
symbol
Battery type
Locking tab
Precautions for battery use:
Remove the battery if the unit will not be used for a long
period of time.
This will prevent potential damage due to battery leakage.
Caution:
 Do not use rechargeable battery (nickel-cadmium bat-
tery, etc.).
 Danger of explosion if battery is incorrectly replaced.
 Replace only with the same or equivalent type.
 Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire
or the like.
 Installing the battery incorrectly may cause the unit to
malfunction.
Notes concerning use:
 Replace the battery if the operating distance is reduced
or if the operation becomes erratic. Purchase “CR
2025”, coin lithium battery.
 Periodically clean the transmitter on the remote control
with a soft cloth.
 Exposing the sensor on the unit to strong light may in-
terfere with operation. Change the lighting or the direc-
tion of the unit if this occurs.
 Keep the remote control away from moisture, heat,
shock, and vibrations.
„ Test of the remote control
The remote control can be used within the range shown
below:
MUTE ON/ STAND-BY
TREBLE
AUDIO IN
BASS
PAIRING
VOL
X-BASS
BLUETOOTH
DIMMER
RRMCGA342AWSA
ECO MODE
Remote sensor
0.2 m - 6 m
(8” - 20’ )
Remote control