Brother IntelliFAX 1360 - Manual (Page 85)

Troubleshooting and Routine Maintenance
77
Note
If the protective yellow cap comes off
when you open the bag, the cartridge will
not be damaged.
e
The ink cartridge has its own correct
position. Insert the ink cartridge in the
direction of the arrow on the label.
f
Lift the lock release lever gently and
push it until it clicks, and then close the
ink cartridge cover.
g
The machine will automatically reset the
ink dot counter.
Note
• If you replaced an ink cantridge before the
LCD shows Near Empty or Ink Empty,
the LCD will ask you to verify that it was a
brand new one. (For example, Did you
change Black?
) For each new cartridge
you installed, Press 1 (Yes) to
automatically reset the colour. If the ink
cartridge you installed is not brand new
one, be sure to press 2 (No).
• If the LCD shows No Cartridge after
you install the ink cartridge, check that the
ink cartridge is installed properly.
WARNING
If ink gets in your eyes, wash them out with
water at once and call a doctor if you are
concerned.
CAUTION
DO NOT take out the ink cartridge if you do
not need to replace it. If you do so, it may
reduce the ink quantity and the machine will
not know the quantity of ink left in the
cartridge.
DO NOT touch the cartridge insertion slots.
If you do so, the ink may stain your skin.
If ink stains your skin or clothing, wash with
soap or detergent at once.
Once you open an ink cartridge, install it in
the machine and use it up within six months
of installation. Use unopened ink cartridges
by the expiration date written on the
cartridge package.
DO NOT dismantle or tamper with the ink
cartridge; this can cause the ink to leak out
of the cartridge.