Changing halogen bulbs, Risk of burns, Caution – Neff B46E74N3GB User Manual

Page 30: Clouding in halogen bulbs, Reinsert the bulb fitting into the appliance door, Fit the door panel and appliance door, Changing the door seal, Unhooking the door seal, Hooking in the door seal, Check that the door seal is seated correctly

Advertising
background image

30

Changing halogen bulbs

Spare bulbs can be obtained from the after-sales service or

specialist retailers. Verwenden Sie nur diese Halogenlampen:
Osram HALOSTAR ECO, 12 V, GY 6.35, 25 W

:

Risk of burns!

Halogen bulbs become very hot when switched on. When
replacing them, wait until the bulb has cooled down.

Caution!
Clouding in halogen bulbs: Do not touch halogen bulbs with

bare fingers. This causes oils to get onto the glass which are

then burnt on and cloud the glass. Use a clean cloth to change

the bulb.

1.

Remove the appliance door (see section: Removing and

refitting the appliance door).

2.

Remove the door panel (see section: Cleaning the door

panels).

3.

Unclip the defective halogen bulb and the bulb fitting from the

holder, and carefully remove it from the reflector.

4.

Remove the defective halogen bulb from the bulb fitting

(fig. A).

5.

Insert a new halogen bulb into the bulb fitting. Use a clean

cloth to do this (fig. B).

6.

Reinsert the bulb fitting into the appliance door.

7.

Fit the door panel and appliance door.

Changing the door seal

If the door seal is defective, it must be replaced. Replacement

seals for your appliance can be obtained from the after-sales

service.

Unhooking the door seal
The door seal is fixed in nine places.

1.

Unhook (Fig. B) the door seal at four points (Fig. A).

2.

Hook the door seal in at five further points (Fig. C) by turning

the hooks slightly (Fig. D).

Hooking in the door seal

1.

Hook (Fig. B) the door seal in at four points (Fig. A).

2.

Hook the door seal in at five further points (Fig. C) by turning

it slightly (Fig. D).

3.

Check that the door seal is seated correctly.

After-sales service

Our after-sales service is there for you if your appliance needs

to be repaired. We will always find the right solution in order to

avoid unnecessary visits from a service technician.

E number and FD number

When calling us, please give the product number (E no.) and

the production number (FD no.) so that we can provide you with

the correct advice. The rating plate containing these numbers

can be found on the base of the appliance when you open the

appliance door.
To save time, you can make a note of the number of your

appliance and the telephone number of the after-sales service

in the space below, should it be required.

Please note that there will be a fee for a visit by a service

technician in the event of a malfunction, even during the

warranty period.
Please find the contact data of all countries in the enclosed

customer service list.

To book an engineer visit and product advice

Rely on the professionalism of the manufacturer. You can

therefore be sure that the repair is carried out by trained service

technicians who carry original spare parts for your appliances.

%

$

$

%

&

'

E no.

FD no.

Aftersales service

O

GB

0844 8928989

Calls from a BT landline will be charged at up to

3 pence per minute. A call set-up fee of up to 6 pence

may apply.

IE

01450 2655

0.03 € per minute at peak. Off peak 0.0088 € per

minute.

Advertising