Belkin ScreenCast AV4 - Manual (Page 12)

C D
10
seTTInG THe PRODUCT UP
figure C
Connect your ScreenCast AV receiver to your HDTV via an
HDMI cable.
Connect your ScreenCast AV receiver to the included power supply
and plug the power supply into an available power outlet. Press the
power button to turn it on.
figure D (Optional Wall-Mount)
The receiver can be wall-mounted with the included hardware
and placement guide. If you are wall-mounting, make sure that
the IR lens on the receiver can be seen by your remotes.
Tip: To test this, mount the ScreenCast receiver, and take any remote
control to where you’ll be watching the HDTV. The ScreenCast
receiver is in a good position if you see a blue flash on the
receiver’s top LED when you press a key on the remote control.
set Up the screenCast aV Receiver
HDMI