Brother FAX-222 - Manual (Page 72)

9 - 10 M E S S A G E C E N T E R ( F O R F A X - 3 3 3 M C O N L Y )
95 Changing Fax Forwarding/
Paging Setting If you hear one long beep, the change is
accepted. If you hear three short beeps, you
cannot change it because the conditions have
not been met (Example: registering paging
number). You can register your fax forwarding
number by using 4. FAX FWD NO. (See page
9-12.) Once you have registered the number,
the fax machine will change automatically to
FAXFWD:ON mode. Then retrieve a Memory
Status List by entering
9 6 1 (See page 9-11.)
to make sure that the Fax Forwarding number
you registered is correct in the List.
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD NO.
96 Retrieve a fax
1 Memory Status List Enter the number of a remote fax machine to
receive a report or stored fax messages. (See
page 9-11.)
2 Retrieve all faxes
3 Erase fax in the memory If you hear one long beep, you can erase the fax
message from the memory.
97 Check the receiving status You can check whether your fax machine has
received any FAX or VOICE messages. If yes,
you will hear one long beep. If no, you will
hear three short beeps.
1 FAX
2 VOICE
98 Change Answer Mode If you hear one long beep, you can change the
answer mode. If you hear three short beeps,
you cannot change it. (Example: There is no
MSG CTR OGM when you want to change to
MSG CTR mode.)
1 MSG CTR
2 FAX/TEL
3 FAX
90 Exit After a long beep, you can exit remote control.
Remote Commands Operation Details