Baby Trend DOUBLE SNAP N GO 1304TW - Manual (Page 11)

Installation Instructions for Evenflo ® On My Way
The Double Snap-N-Go ® will accommodate the Evenflo ® On My Way
Infant Car Seat. Please follow the following instructions for proper
installation of the On My Way.
Front Seat:
1. Remove (unscrew) Crossbars A1, C, B1 and D from the Double Snap-N-
Go ® frame. Remove the Car Seat Straps from the Double Snap-N-Go ®
frame. Retain the screws you remove.
2. Attach Crossbar B1 with sleeve to the Double Snap-N-Go ® frame using
the two holes labled #4 as shown in figure 1. use the two screws that you
removed in step 1.
3. Attach Crossbar C to the Double Snap-N-Go ® frame using the two holes
labeled #6 as shown in figure 1. Use the two screws that you removed in
step 1.
4.Attach the Car Seat Straps to the Double Snap-N-Go ® frame using the two
holes labeled 5 as shown in figure 1. Use the two screws that you removed
in step 1.
Rear Seat:
1. Remove (unscrew) Crossbars A2, B2, and B1 from the Double Snap-N-
Go ® frame. Retain the screws you remove.
2. Attach Crossbar B2, so that the bent section faces down, to the Double
Snap-N-Go ® frame using the two holes labeled #3 as shown in figure 2.
Use the two screws that you removed in step 1.
Insertion of the Evenflo ® On My Way Infant Car Seat
1. With one hand grasp the car seat handle (in its upright, carrying position)
and gently place the seat, so that the baby faces the rear of the Double
Snap-N-Go ® , onto the Double Snap-N-Go ® so that the large groove on
the seat bottom, nearest the head-end of the seat, hooks over Crossbar
C in the front or crossbar B2 in the rear. Check that the seat locked onto
the Crossbar. See Figure 3. FOR SAFE OPERATION, IT IS VERY
IMPORTANT THAT THE SEAT LOCK SECURELY ONTO THE
CROSSBAR.
2. Feed the Car Seat Straps through the auto belt slots on the infant car seat as
shown in Figure 4 and snap the two buckles together. The first time your
do this, you will need to adjust the length of the strap for a tight fit around
the car seat. FOR SAFE OPERATION, IT IS VERY IMPORTANT
THAT THE CAR SEAT STRAP IS ALWAYS TIGHTLY FASTENED
OVER THE CAR SEAT.
3. Test for secure installation by moving the car seat in all directions. The
car seat should be securely attached to the Double Snap-N-Go ® .
Removal of the Evenflo ® On My Way Infant Car Seat
1. Unlock the Car Seat Strap and remove from over the infant car seat.
2. With one hand, grasp the car seat handle (in its upright, carrying position)
and with your other hand squeeze the red handle on the back of the car
seat and lift the car seat upward from the Double Snap-N-Go ® frame. See
Figure 5.
11
Bar B1
Sleeve
Hole #6
Hole #5
Hole #4
Strap
Bar B2
down
Hole #3
Hole #5
Strap
Bar C
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Evenflo ® and On My Way are the trademarks of their owners. They are not
associated with Baby Trend and no approval or endorsement is implied.