Baby Trend DOUBLE SNAP N GO 1304TW - Manual (Page 12)

Installation Instructions for Graco ® Snug Ride
The Double Snap-N-Go ® will accommodate the Graco ® Snug Ride Infant
Car Seat. Please follow the following instructions for proper installation of
the Snug Ride.
Front Seat:
1. Remove (unscrew) Crossbars B1, and C from the Double Snap-N-Go ®
frame Remove the Car Seat Straps from the Double Snap-N-Go ® frame.
Retain the screws you remove.
2. Attach the Car Seat Straps to the Double Snap-N-Go ® frame using the
two holes labeled #5 as shown in figure 1. Use the two screws that you
removed in step 1.
Rear Seat:
1. Remove (unscrew) Crossbars B2 and B1 from the Double Snap-N-Go ®
frame. See figure 2.
Insertion of the Graco ® Snug Ride Infant Car Seat
1. With one hand grasp the car seat handle (in its upright, carrying position)
and gently place the seat, so that the baby faces the rear of the Double
Snap-N-Go ® , onto the Double Snap-N-Go ® so that the large groove on the
seat bottom, nearest the head-end of the seat, hooks over Crossbar A1
in the front or crossbar A2 in the rear. Check that the seat locked onto
the Crossbar. See Figure 3. FOR SAFE OPERATION, IT IS VERY
IMPORTANT THAT THE SEAT LOCK SECURELY ONTO THE
CROSSBAR.
2. Feed the Car Seat Straps through the auto belt slots on the infant car seat
as shown in Figure 4 and snap the two buckles together. The first time
your do this, you will need to adjust the length of the strap for a tight
fit around the car seat. FOR SAFE OPERATION, IT IS VERY IM-
PORTANT THAT THE CAR SEAT STRAP IS ALWAYS TIGHTLY
FASTENED OVER THE CAR SEAT.
3. Test for secure installation by moving the car seat in all directions. The
car seat should be securely attached to the Double Snap-N-Go ® .
Removal of the Graco ® Snug Ride Infant Car Seat
1. Unlock the Car Seat Strap and remove from over the infant car seat.
2. With one hand, grasp the car seat handle (in its upright, carrying posi-
tion) and with your other hand squeeze the handle on the back of the car
seat and lift the car seat upward from the Double Snap-N-Go ® frame. See
Figure 5.
Bar A1
Hole #5
Hole #7
Hole #1
Strap
Bar D
Strap
Hole #2
Bar A2
Hole #5
12
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Graco ® and Cozy Carry are the trademarks of their owners. They are not
associated with Baby Trend and no approval or endorsement is implied.