Baby Trend DOUBLE SNAP N GO 1304TW - Manual (Page 14)

Installation Instructions for Baby Trend ® Latch-Loc ®
The Double Snap-N-Go ® will accommodate the Latch-Loc ® Infant Car
Seat. Please follow the following instructions for proper installation of the
Latch Loc.
Front Seat:
1. Remove (unscrew) Crossbars A1, B1, and C and D from the Double
Snap-N-Go ® frame Remove the Car Seat Straps from the Double Snap-N-
Go ® frame. Retain the screws you remove.
2. Attach the Car Seat Straps to the Double Snap-N-Go ® frame using the
two holes labeled #5 as shown in figure 1. Use the two screws that you
removed in step 1.
3. Attach Crossbar C, to the Double Snap-N-Go ® frame using the two holes
labeled #7 as shown in figure 1.
Rear Seat:
1. Remove (unscrew) Crossbars A 2, B2 and B1 from the Double Snap-N-
Go ® frame. See figure 2.
Insertion of the Latch-Loc ® Infant Car Seat
1. With one hand grasp the car seat handle (in its upright, carrying position)
and gently place the seat, so that the baby faces the rear of the Double
Snap-N-Go ® , onto the Double Snap-N-Go ® so that the large groove on the
seat bottom, nearest the head-end of the seat, hooks over Crossbar BT1
in the front or crossbar BT2 in the rear. Check that the seat locked onto
the Crossbar. See Figure 3. FOR SAFE OPERATION, IT IS VERY
IMPORTANT THAT THE SEAT LOCK SECURELY ONTO THE
CROSSBAR.
2. Feed the Car Seat Straps through the auto belt slots on the infant car
seat as shown in Figure 4 and snap the two buckles together. The
first time your do this, you will need to adjust the length of the strap
for a tight fit around the car seat. FOR SAFE OPERATION, IT IS
VERY IMPORTANT THAT THE CAR SEAT STRAP IS ALWAYS
TIGHTLY FASTENED OVER THE CAR SEAT.
3. Test for secure installation by moving the car seat in all directions. The
car seat should be securely attached to the Double Snap-N-Go ® .
Removal of the Latch-Loc ® Infant Car Seat:
1. Unlock the Car Seat Strap and remove from over the infant car seat.
2. With one hand, grasp the car seat handle (in its upright, carrying position)
and with your other hand squeeze the handle on the front of the car seat
and lift the car seat upward from the Double Snap-N-Go ® frame. See
Figure 5.
BT1
Hole #5
Hole #7
Strap
Strap
Hole #5
BT2
Bar C
14
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Baby Trend ® and Latch-Loc are the trademarks of their owners. They are
not associated with Baby Trend and no approval or endorsement is implied.