BT 4000 Classic - Manual (Page 38)

Diverse 4000 Classic ~10th Edition ~ 19th September ’01 ~ 4167
36
Help
Problem Possible cause Solution
Handset not registering The batteries in the handset Check that you have fitted
are fitted incorrectly. the batteries correctly.
No display Handset not switched on Hold down the RED PHONE
button for 1 second
Batteries exhausted Charge or replace
batteries
When you press a button, Keyguard may be Hold down the #
nothing happens switched on button for 1 second
No radio signal to Handset out of range Move closer to the base
the base – all displays Handset not registered Register the handset
flashing (see page 11)
Base not switched on Check the base is
connected properly
(see page 10)
Handset/base does Ringer is switched off Switch ringer back on,
not ring (see page 31)
Your caller cannot The INT button has been, Press the GO BACK
hear you pressed, muting the options button to switch
microphone the microphone back on
Caller’s number is not The number has been Callers can stop their
displayed even though withheld number being sent over
you have subscribed the network
to Caller Display
The error beep – You have pressed the Retry. If necessary, check
a descending tone is wrong button the instructions
played
HELP