Philips SHAVER Series 5000 afeitadora eléctrica en seco - Manual (Page 14)

Cleaning the shaving unit in the Jet Clean system
(PT927CC/PT923CC only)
The Jet Clean System cleans the shaving unit.
Preparing the Jet Clean system for use
Note: Fill the cleaning chamber before first use and when the ‘fluid low’ symbol
flashes to indicate that the fluid level is too low. When the fluid level drops
below the minimum level, the cleaning symbol and the ‘fluid low’ symbol start
to flash and the shaver holder returns to its starting position
1 Simultaneously press the release buttons on both sides of the
cleaning chamber (A). Then lift the Jet Clean System off the cleaning
chamber (B).
, The cleaning chamber remains behind.
2 Unscrew the cap from the bottle with Jet Clean solution
(HQ200) and remove the airtight seal.
3 Fill the cleaning chamber with Jet Clean solution (HQ200) up to the
MAX indication.
Note: Make sure the cleaning chamber is always filled above the MIN
indication.
4 Place the Jet Clean System back onto the cleaning chamber (‘click’).
Make sure that the release buttons snap back into place.
When the cleaning chamber is filled with Jet Clean solution, do not move
it to prevent leakage.
5 Put the small plug in the Jet Clean System and put the adapter in the
wall socket.
, The shaver holder automatically moves to its highest position.
The Jet Clean System is now ready for use.
using the Jet Clean system
1 Place the shaver without protection cap upside down in the shaver
holder. Push down the locking lever completely to lock the shaver
into place.
, The battery symbol on the Jet Clean System goes on to indicate that
the shaver is being charged.
Note: The shaver cannot be placed in the Jet Clean System when the protection
cap is on the shaving unit.
English
14