Bush Hog SM 60 User Manual

Page 20

Advertising
background image

5-1 BASIC MACHINE ASSEMBLY

BASE UNIT IS EXTREMELY TOP
HEAVY WHEN DISCONNECTED
FROM CUTTER DECK AND SHOULD
BE MOVED ONLY BY CONNECTING
TO TRACTOR 3-POINT HITCH. DO
NOT REMOVE WOODEN SUPPORT
UNLESS UNIT IS CONNECTED TO
TRACTOR 3-POINT HITCH OR OVER-
TURNING WILL RESULT.

A. Connect base unit to tractor 3-point hitch.
B. Remove wooden support.
C. With cutter deck flat on ground, connect it to

base unit using pivot pin, two washers and roll pins.

D. Connect lift linkage to cutter deck with pin and

roll pins. It may be necessary to remove cylinder
port caps to extend cylinder. With port caps
removed, watch out for oil spraying out of cylinder
ports.

E. Remove cover plate and gasket from spindle

housing on cutter deck. Remove O-ring gasket
packed inside spindle housing and retain for motor
installation.

F. Fill spindle housing with 26 fl. oz. of EP80W-

90 gear oil or until oil reaches check plug.

G. Mount hydraulic motor to spindle housing using

O-ring gasket to seal. Fasten with nuts, bolts and
lockwashers removed from cover plate.

H. Assemble hydraulic valve kit (Fig. 5-1) or tractor

kit (Fig. 5-2). Use pipe joint compound on pipe fit-
tings only. Do not use thread tape. Do not over-
tighten fittings.

I. Check hydraulic oil level. Fill as needed to bring

oil level to bottom of filler strainer. See paragraph 4-
3 for compatible hydraulic oils.

Fold Cyl.

Slide Cyl.

Slide Cyl.

Fold Cyl.

17

Figure 5-1 Hydraulic Valve Kit

Hyd. Hose 120”

Hyd. Valve

90° Elbow Adaptor 3/4” JIC to 3/4” ORB (Not Shown)

or

90° Elbow Adaptor 3/4” JIC to 1/2” NPT

90° Elbow

1-1/16” ORB to 3/4” JIC

Straight Adaptor

7/8” ORB to 9/16” JIC

Hyd. Hose 144”

90° Elbow

Hyd. Fitting

90° Elbow

9/16” JIC Male to Female

Hyd. Hose 96”

90° Elbows

Hyd. Hose 108”

90° Elbow

7/8” ORB to 3/4” JIC

Breather Plug

(Shipped in Cylinder, not Part of Hyd. KIt

Figure 5-2 Tractor Hydraulic Kit

Straight Adaptor 1/2” NPT to 9/16” JIC

or

Straight Adaptor 3/4” ORB to 9/16” JIC

Hyd. Hose 108”

Hyd. Hose 108”

Hyd. Hose 48”

90° Elbows

90° Elbow

Breather Plug

(Sjipped in Cylinder, not Part of Hyd. Kit)

CAUTON

Advertising