Philips BEARDTRIMMER Series 7000 barbero con sistema de aspiración turbo - Manual (Page 13)

1 Disconnect the appliance from the mains and let the appliance run
until the motor stops.
2 Remove the two side panels with a screwdriver (Fig. 18).
3 Remove the front panel with a screwdriver. (Fig. 19)
4 Pull out the printed circuit board (Fig. 20).
5 Detach the rechargeable battery from the printed circuit board
with a screwdriver. Then bend or turn the battery several times
until the connections break (Fig. 21).
guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your
country.
Problem Possible
cause
Solution
The
trimmer
does not
work when
it is
switched on
and the red
battery-low
light flashes.
The battery is
empty.
Charge the appliance fully (see chapter
‘Charging’). It takes approximately 70
minutes to charge the appliance fully.
English 13