Beyonwiz FV-L1 - Manual (Page 33)

Quick Setup
26
2) Audio Outputs
The FV-L1 supports 5.1ch audio via the RCA connectors on the rear of
the unit and will decode and output Dolby Digital via a built in decoder.
It also supports digital outputs with optical and coaxial ports.

Audio Format: Select one of the following options to suit your chosen
audio connection in the “Audio Connection” section in Chapter 3;
 2ch – for stereo speaker connections.

5.1ch – for 5.1 speaker connections.

passthrough – to use an external audio decoder (e.g. amplifier).
 S/PDIF Output: Select “Enable” if using the digital audio output
through the coaxial and optical ports.

Dolby D Compression: Select either of the following options;

Line Mode – recommended for most users.

RF Mode – recommended for when audio is connected directly to
the TV using RF cables.
NOTE

If you set the audio format to 2ch, the FV-L1 mixes down 5.1ch audio
source to 2ch audio.

If the content of a channel broadcasted has 2ch audio source, the FV-
L1 cannot expand the 2ch audio source to 5.1ch audio format.
Therefore, you will only hear sound from the front speakers even
though you have connected a 5.1ch speaker system and set the FV-
L1 as 5.1ch audio.
3) Colour Setting
You can adjust the colour output of the FV-L1.
The three options are brightness, contrast and saturation. Use the
UP/DOWN buttons to select each option, and adjust the setting with
the LEFT/RIGHT buttons. You can restore all colour settings to the
factory default values by pressing the RED button. To apply your
chosen settings, use the UP/DOWN buttons to select “Accept” and
press OK. To cancel the new settings, select “Cancel” and press OK, or
press the EXIT button.