Beyonwiz FV-L1 - Manual (Page 66)

STB & PVR Function
59
2) Timer Overlaps Two Current Recordings
If a new timer begins while two recordings are already in progress, the
following timer conflict dialog will be displayed:
In order to allow the timer to begin, you must stop one of the current
recordings. Use the UP/DOWN buttons to select a recording and
press OK to stop that recording. If you don’t wish to stop either of the
current recordings, press EXIT to cancel the pending timer.
NOTE

The new timer is given a higher priority than the existing recordings.
Therefore, if you are unable to respond to the timer conflict dialog
within 1 minute, the current recording which is scheduled to finish
sooner will be stopped to allow the new timer to begin.
3) Timer Overlaps Current Recording on Same Service
If a timer overlaps a current recording on the same service, the
following timer conflict dialog will be displayed:
In order to allow the timer to begin, you must stop the current
recording by pressing the OK button. If you don’t wish to stop the
current recording, press EXIT to cancel the pending timer.
NOTE
 The new timer is given a higher priority than the existing recording.
Therefore, if you are unable to respond to the timer conflict dialog
within 1 minute, the current recording will be stopped to allow the
timer to begin