West Bend Back to Basics CC500 - Manual (Page 7)

7
7. Press the “ON/AUTO/OFF” button. The red “BREW” light will
illuminate during operation.
8. Upon completion of brew cycle, wait 1 minute before removing carafe
from the unit to allow any remnants to fi lter through. Dispense coffee
by one of the following methods:
A. Remove carafe and pour desired amount into cup(s). To keep
coffee warm, place the carafe back on the warming plate found on
the unit. WARNING: With the carafe off the unit, the warming
plate is exposed. Do not touch.
B. If only 1 cup is desired, you may use the one-hand dispensing
feature, under the carafe. To dispense, press cup against the One-
Hand Dispensing Button to release liquid into cup. Fill cup to the
desired amount. When desired amount is reached, release pressure
from One-Hand Dispensing Button. The carafe will stay warm
because of the warming plate on the unit.
9. Switch unit to off by pressing the “ON/AUTO/OFF” button 2 times.
The red “BREW” light will no longer be illuminated. Remove carafe
and fi lter for cleaning.
10. Wait 10 minutes before brewing a second pot of coffee. Repeat
steps 1-10. Be sure unit is in the off position if the unit was left on
for over a 2-hr period. The unit is designed to automatically shut off
after 2-hours. Switch power to “OFF” when carafe is empty or when
the unit is not in use. NOTE: The second push of the ON/AUTO/OFF
button activtes the “AUTO” function when the green “AUTO” light is
illuminated.
OPERATION
One-Hand Dispensing Button