Bay Technical Associates DS72 User Manual

Page 24

Advertising
background image

DS72 HOST MODULE OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

19

Enter the Module IP Address (Example: 200.4.3.50), followed by <cr>.
The DS72 resumes the configuration menu.Default Module IP Address
is 0.0.0.0.

If you fail to enter the Module IP Address in dotted decimal form, the
DS72 responds again:

Enter Module IP address in dotted decimal form:

The DS72 responds indefinitely with the same request until the Module IP
Address in entered in the correct form.

NOTE: There should be no active connections while configuring the DS72 module. The unit
should be reset upon completion of configuration.

Subnet Mask The Subnet Mask is a bit mask that identifies the network portion of the IP

address, allowing the DS72 to determine whether to send a packet directly
to the client or to a gateway. The Subnet Mask consist of four bytes, each
byte ranging from 0 to 255. This parameter must be programmed
before the DS-Series can be accessed through the network
.

From the configuration menu, select #2, “Subnet Mask,” followed by
<cr>. The DS72 responds:

Enter Subnet Mask in dotted decimal form:

Enter the Subnet Mask (Example: 255.255.255.0), followed by <cr>. The
DS72 resumes the configuration menu. Default Subnet Mask is 0.0.0.0.

If you fail to enter the Subnet Mask in dotted decimal form, the DS72
responds again:

Enter Subnet Mask in dotted decimal form:

The DS72 responds indefinitely with the same request until the Subnet

Mask is entered in the correct form.

Gateway

The Gateway is the address of a router for connection to their networks.
The Gateway address consists of four bytes, each byte ranging from 0 to
255. If your network uses gateways, this parameter must be programmed
before the DS72 can be accessed through a network.

From the configuration menu, select #3, “Gateway,” followed by <cr>.
The DS72 responds:

Enter Gateway address in dotted decimal form:

Enter the Gateway address (Example: 200.4.5.50), followed by <cr>. The
DS72 resumes the configuration menu. Default Gateway address is
0.0.0.0.
If you fail to enter the Gateway address in dotted decimal form,
the DS72 responds again:

Advertising