Philips Flat TV - Manual (Page 66)

6
Program sort
& Press key H
.The TV Menu is displayed on
the screen.
é With the cursor, select the Install menu
followed by the Sort menu.
“ Select the programme you want to move using
the
îÏ
keys and press
¬
.
‘ Then use the îÏ
keys to select the new
number and validate with
È
.
( Repeat steps “ and ‘ for each program you
wish to renumber.
§ To quit the menus, press d
.
TV Menu
Picture
Sound
Features
Install
Mode
Quick installation
When you turn on the TV set for the first
time, a menu is displayed on screen.This menu
prompts you to select the country and
language for the menus:
w
If the menu is not displayed, press and hold down
the
”
+ and
”
- keys on the TV set for 5
seconds to display the menu.
& Use the îÏ
keys on the remote control to
select your country and validate with
¬
.
If your country does not appear in the list, select
choice “. . .”
é Next select your language using the îÏ
keys and validate with
¬
.
“ The search starts automatically.All the available
TV programmes and radio stations will be
stored. This operation takes a few minutes.The
display shows the progress of the search and
the number of programs found. At the end of
the search, the menu disappears.
To exit or interrupt the search, press
H
. If no
programme is found, consult the possible solutions p. 12.
‘ If the transmitter or cable network sends the
automatic sort signal, the programs will be
numbered correctly. In this case, the
installation is complete.
( If this is not the case, you need to use the
Sort menu to number the programs correctly.
Some transmitters or cable networks broadcast
their own sort parameters (region, language, etc.).
In this case, indicate your choice using the
îÏ
keys and validate with
¬
.
Plug’n’Play
Country
GB
Language
English
Install
Language Æ •
Country Æ •
Auto Store Æ •
Manual Store Æ •
Sort Æ •
•
0
1
2
3
4
5
To switch on the set, press the on/off key. A
green indicator comes on and the screen
lights up. Go straight to the Quick
Installation chapter. If the TV remains in
standby mode(red indicator), press the P
#
key on the remote control.
The indicator will flash when you use the remote
control.
Switching on
PROGRAM VOLUME