Philips AquaTrio Sistema de aspiración y limpieza húmeda - Manual (Page 25)

25
Problem Possible cause Solution
The mopping nozzle
lid is not closed
properly. The sound
of the appliance
decreases and the
appliance no longer
applies water to the
floor because the
mopping brushes do
not rotate and the
appliance does not
mop up anything.
Make sure the mopping brushes and the mopping brush
cover are assembled correctly. Close the mopping nozzle
lid properly. Make sure you press the lid until it locks with
a click (see chapter ‘Cleaning and maintenance’, section
‘Reassembling the mopping nozzle’).
The inside of the
mopping nozzle is
too dirty.
Clean the mopping nozzle (see chapter ‘Cleaning and
maintenance’, section ‘Cleaning the mopping nozzle’).
The mopping brushes
are not present.
Place the mopping brushes in the mopping nozzle
(see chapter ‘Cleaning and maintenance’, section
‘Reassembling the mopping nozzle’).
The mopping brushes
are worn.
Replace the mopping brushes (see chapter ‘Replacing the
mopping brushes’).
The sound of
the appliance
changed while
cleaning.
The active protection
system may have
been activated for
three reasons: (1) the
appliance picked up
a foreign object, (2)
the mopping brushes
are too wet or (3)
you have moved
the appliance over a
carpet. The mopping
brushes automatically
stopped rotating
because they
encountered too
heavy resistance. The
appliance continues
to make a sound,
but it does not work
properly.
Release the power-on button to switch off the appliance.
Put the appliance upright in parking position (‘click’) and
pull the plug out of the wall socket. Open the mopping
nozzle lid, remove the mopping brush cover and remove
the object. Reinsert the mopping brush cover, close the
mopping nozzle lid, put the plug in the wall socket and
switch on the appliance again (see chapter ‘Using your
AquaTrio’, section ‘Active protection system is activated’).
If you find no object, the active protection system may
have been activated because the mopping brushes are
too wet (see next cause and solution) or because you
moved the appliance over a carpet. Pull the plug out
of the wall socket, open and close the mopping nozzle
lid, put the plug in the wall socket again, switch on the
appliance and start cleaning again.
If the above solutions did not help and the appliance still
does not work, switch on the appliance for at least 10
seconds. Then open and close the mopping nozzle lid,
switch on the appliance and start cleaning again.
EN
gl
IS
h