Philips AquaTrio Sistema de aspiración y limpieza húmeda User Manual

Page 27

Advertising

Problem

Possible cause

Solution

I have just filled

the clean water

tank, but the

tank full/tank

empty light keeps

flashing when I

switch on the

appliance.

The tank full/tank

empty light may flash

a few times when

you switch on the

appliance after you

have filled the clean

water tank.

When you switch on the appliance after you have filled

the clean water tank, the tank full/tank empty light may

flash a few times and the appliance may switch off

automatically. This happens because it takes a few seconds

for the water to reach the mopping nozzle. Release the

power-on button. Then push the unlock slide forwards and

press the power-on button to switch on the appliance

again (see chapter ‘Preparing for use’, section ‘Filling the

clean water tank’).

If the tank full/tank

empty light continues

to flash after filling,

the clean water

tank may not be

assembled properly.

Make sure you place the clean water tank properly and

that the lever is locked (see chapter ‘Preparing for use’,

section ‘Filling the clean water tank’).

Water drips out

of the appliance.

Water leaks from

the clean water tank

because you have

not put the cap on

the clean water tank

or you have not

fastened this cap

properly.

Remove the clean water tank from the appliance. Put

the cap on the water tank if it was not there or turn the

cap clockwise to fasten it (see chapter ‘Preparing for use’,

section ‘Filling the clean water tank’).

Water leaks from

the clean water

tank because you

overfilled the clean

water tank.

Do not fill the clean water tank beyond the MAX

indication. If you do, water may spill from the clean water

tank when you fasten the cap (see chapter ‘Preparing for

use’, section ‘Filling the clean water tank’).

Water leaks from

the dirty water tank

because you tilted

the upper body too

far backwards or

because you placed

the appliance on

its side. This caused

wastewater to run out

of the dirty water tank.

Do not tilt the upper body of the appliance too far

backwards, for instance when you clean under a low

table. Do not place the appliance on its side when

there is wastewater in the dirty water tank (see chapter

‘Important’, section ‘Caution’).

I cannot remove

the mopping

brushes.

You probably tried

to remove them by

pulling at the wrong

side.

grab the lime green grips of the brushes and pull the

brushes up a little. Then you should be able to slide

them off the projection on the other side (see chapter

‘Cleaning and maintenance’, section ‘Cleaning the

mopping nozzle’).

I cannot tilt

the appliance

backwards

without the

nozzle coming off

the floor.

The appliance is

locked in parking

position.

Press the nozzle with your foot and release the appliance

from parking position (see chapter ‘Using your AquaTrio’,

section ‘Pausing during use’).

Advertising