Philips SHAVER Series 3000 Afeitadora eléctrica - Manual (Page 10)

Note: The travel lock cannot be activated when the
shaver is connected to the mains.
Activating the travel lock
1 Press the on/off button for 4 seconds to enter
the travel lock mode (your display may differ
from the one shown in the figure).
The lock symbol appears on the display and the
power-on symbol lights up for a few seconds to
indicate that the travel lock has been activated.
Note: When you push the on/off button during less
than 4 seconds while the shaver is in the travel lock
mode, the lock symbol and the power-on symbol in the
on/off button flash for a few seconds.
Deactivating the travel lock
1 Press the on/off button for 4 seconds.
The lock symbol disappears and the motor
starts running to indicate that the travel lock has
been deactivated.
The shaver is now ready for use again.
Note: When you start charging, the travel lock is
automatically deactivated.
Charging
It takes approx. 60 minutes to fully charge the
battery.
When you charge the shaver for the first time or
after a long period of disuse, let it charge for 4 hours.
Tip: To optimise the battery capacity, fully charge the
shaver and then use it normally until the battery is
completely empty. Repeat this process three times in a
row. If you optimise the battery capacity in this way, you
,
,
ENGLISH 12
4222.002.4998.2.indd 12 27-02-2009 11:34:11