Philips SHAVER Series 3000 Afeitadora eléctrica - Manual (Page 14)

Note: Water may leak from the socket at the bottom of
the appliance when you rinse it. This is normal and not
dangerous.
Cleaning the shaving unit in the Jet Clean
System
The Jet Clean System cleans the shaving unit.
Preparing the Jet Clean System for use
Fill the cleaning chamber before first use and
when the ‘fluid low’ symbol flashes to indicate
that the fluid level is too low. When the fluid level
drops below the minimum level, the cleaning
symbol and the ‘fluid low’ symbol start to flash
with intervals and the holder returns to its starting
position.
1 Simultaneously press the release buttons on
both sides of the cleaning chamber (1). Then lift
the Jet Clean System off the cleaning chamber
(2).
The cleaning chamber remains behind.
2 Unscrew the cap from the bottle with
HQ200 cleaning fluid and remove the airtight
seal.
3 Fill the cleaning chamber with HQ200 cleaning
fluid up to the MAX indication.
Note: Make sure the cleaning chamber is always filled
above the MIN indication.
4 Place the Jet Clean System back onto the
cleaning chamber.
Make sure that the release buttons snap back into
place.
-
,
ENGLISH 16
4222.002.4998.2.indd 16 27-02-2009 11:34:18