Beyerdynamic MCS 20 User Manual

Page 40

Advertising
background image

MCS 20 – MCS 223 Microphone Unit

40

Step 1 – Set limit to 01

The limit for the selected operating mode (“Free” or “Request”) should be set to 01. With a limit of >1 the
displayed speech time of the microphone unit turned on first applies to all microphone units turned on within the
limit. Consequently, these microphone units will also be turned off, when the first microphone unit is turned off.

Step 2 – Settings

The settings can be programmed and differ from the standard settings. Refer to chapter 3.3.8 “Programming
mode”. The settings of the timer codes no. 16 - 21 are stored when the system is turned off and are not reset
when the standard values are accessed.
Note: If the speech time 00 is selected (no. 20 and 21 to 00) and no. 17 or no. 19 are set to 0, the elapsed
speech time is displayed starting with 0 when the microphone is turned on (timer display counts forwards instead
of backwards).

Step 3 – Activate timer function without clearing turned on microphones

Hold down the “Prior” button

ቨ and press the “Clear” button ቩ briefly. The timer function is displayed by two

full stops in the display

ቫ.

OR

Activate timer function with clearing all turned on microphones
Hold down the “Clear” button

ቩ and press the “Prior” button ቨ briefly. The function is displayed by two full

stops in the display

ቫ.

No.

Description

Values

Standard

(factory setting)

16

Warning signal in the “Free” mode before the speech
time has elapsed;
0 = no acoustic warning signal

0 ... 59 sec.

45

17

After the speech time has elapsed in the “Free” mode;
0 = Timer displays the exceeded speech time
1 = MCS 221 is turned off

0 or 1

0

18

Warning signal in the “Request” mode before the
speech time has elapsed;
0 = no warning signal

0 ... 59 sec.

45

19

After the speech has elapsed in the “Request” mode:
0 = Timer displays exceeded speech time (counts up)
1 = Timer stops (turned on MCS 221 must be released by
the chairman via the “Requ” button).
2 = Timer starts again (turned on MCS 221 is turned
off and registered MCS 221 is turned on)

0 ... 2

2

20

Speech time in minutes (applies to “Free” and
“Request” mode) no. 20 and 21 are added.

0 ... 99 min.

2

21

Speech time in seconds (applies to “Free” and
“Request” mode) no. 20 and 21 are added.

0 ... 59 sec.

30

Advertising