Troubleshooting (continued), Please do not return this product to the store, Dirtlifter powerbrush does not turn – Bissell 7950 User Manual
Page 21: Carpet protector is not spraying, Cleaner not picking up solution
21
Troubleshooting (continued)
DirtLifter PowerBrush does not turn.
Possible Causes
Remedies
The Brush Belt or Pump Belt is off or broken.
Turn the machine OFF and unplug from
the outlet. To check if the Brush Belt or Pump
Belt has broken, you will need a flat head
screwdriver. Insert the blade end into the
lower slot of the Belt Access door to release
the lower snap. If necessary, insert the blade
end into the upper slot to release the upper
snap. Examine the belt for breakage. If broken
refer to pages 18-19.
Carpet Protector is not spraying.
Possible Causes
Remedies
Tank not connected properly to the tool.
Follow instructions on cartridge
assuring proper fit.
Solution clogging the Spray trigger.
Soak applicator tool only in hot water.
Spray without the cartridge attached to
purge any residual Solution left in the tool.
Applicator tool spray is blocked.
Soak applicator tool only in hot water.
Spray without the cartridge attached to purge
any residual Solution left in the tool.
SmartMix not set on water/rinse
Set to proper setting.
carpet protector setting.
ReadyTool dial not set on tool setting.
Set to tool setting.
Cleaner not picking up solution.
Possible Cause
Remedies
Ready Tools dial may be at the
Set ReadyTools dial to either Tools or
wrong setting for the cleaning job.
PreTreat or Floor Cleaning.
Nozzle Window may not be properly attached.
Press down firmly on the black oval gasket at
the top window to make sure the two tabs on
the back of the Nozzle Window are snapped
into the mating slots in the main housing.
Tank-in-Tank lid is not properly installed.
Re-install lid; refer to page 8.
Tank-in-Tank is not properly seated.
Tank-In-Tank must be firmly seated to
function; remove and reseat Tank-in-Tank.
Poor tool position. (Hand held attachments only).
Adjust angle; apply more downward pressure.
Tank-in-Tank has picked up maximum dirty water.
Empty Tank-in-Tank, refer page 8
Thank you for selecting a BISSELL product.
If you should happen to need assistance during assembly or operations, call 1-800-237-7691.
Please do not return this product to the store
1
1
2
2
3
3
1
1
4
4
5
5
1
1
2
2
3
3
4
4
5
5
6
6
ug310-5861_7950_205.indd 21
ug310-5861_7950_205.indd 21
3/11/05 8:31:27 AM
3/11/05 8:31:27 AM