Philips Lampe infrarouge InfraCare - Manual (Page 11)

troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
Problem Possible cause Solution
The appliance
does not go on.
The plug is
not inserted into the
wall socket properly.
Put the plug in the wall socket properly.
There is a power
failure.
Connect another appliance to check if the power
supply works.
The lamp is defective. Contact the Philips Consumer Care Centre.
The mains cord is
damaged.
If the mains cord is damaged, you must have it
replaced by Philips, a service centre authorised by
Philips or similarly qualified persons in order to avoid
a hazard.
specifications
Model HP3631
Rated voltage (V) Hongkong/Singapore/Europe 220-230
Rated voltage (V) China/Korea 220
Rated voltage (V) Malaysia 240
Rated voltage (V) Taiwan 110
Rated frequency (Hz) Hongkong/Singapore/
Europe
50-60
Rated frequency (Hz) China/Malaysia 50
Rated frequency (Hz) Korea/Taiwan 60
Rated input (W) 300
Class II
Classification not classified
Ingress of water IPX0
IR type IR-A/B/C
Irradiance (W/m²) approx. 900
Field dimensions (in cm²) 40x30
Battery type LR54
Operation conditions
Temperature from +10°C to +35°C
Relative humidity from 30% to 90%
EnglisH 11