Bradley Smoker EXPRESS CRS-3/IR - Manual (Page 6)

Installation Instructions continued . . .
Step 6: Install drain spud
1. Assemble the P-trap by (supplied by installer)
connecting the 1-1/2" tubular pipe to the 1-1/4"
tailpiece and to the 1-1/2" drain pipe stubbed out
of the wall (see Figure 4).
Step 7: Connecting Supply
1. Connect the 1/2" NPT female end of the
stop/check valves to the rough-ins.
2. Connect one end of the supply hoses to the
stop/check valves.
IMPORTANT: The hose attached to the hot
water inlet of the Vernatherm™
TMV valve must be connected
to the hot water rough-in.
3. Connect the other end of the supply hoses to the Vernatherm™ TMV valve assembly.
4. OPTIONAL SINGLE-TEMPERED SUPPLY: Attach the stop/check valve to the 1/2" tempered
supply line. Connect the stop/check valve to the solenoid valve with the flexible supply hose.
NOTE: The thermostatic mixing valve requires at least 115° F water from the hot water side for
proper operation. As with all lavatories, there will be a delay in obtaining warm water. If the hot
water is too far away from the washfountain, a circulating pump may be required.
Express ® Crescent ® Lavatory System - CRS-Series
CRS-2/IR, CRS-3/IR Installation Instructions
6 2/8/07 Bradley Corporation • 215-1330 Rev. K; EN 06-915
Figure 4
STRAINER
AND
TAILPIECE
269-1584
DRAIN ASSEMBLY
1/4" RUBBER
WASHER
P-TRAP
(polypropylene)
269-1697
FIBER
WASHER
NUT
TRIM TO FIT
Figure 5
VALVE
MOUNTING
BRACKET
FLEXIBLE
SUPPLY HOSE
HOT
SUPPLY
COLD
SUPPLY
STOP/CHECK
VALVE
VERNATHERM™
MIXING VALVE
HOT SUPPLY INLET
VERNATHERM™
MIXING VALVE
COLD SUPPLY INLET