Belkin F1U119 - Manual (Page 22)

18
Troubleshooting (continued)
Problem: Errors such as “Parameter Not Set” or “Parameter Not Correct”
or “Illegal Function” are showing up.
Solutions:
• Restart Windows ® .
• Disable the printer's bi-directional software (see attached document).
• When connecting one computer to four printers, make sure the
switches are set correctly. See page 7.
• Confirm cable from the PC to the AutoSwitch is straight-through, Belkin
Part# F3D111-XX. If you have a Belkin Part# F3D508-XX (or any
Interlink
™ /Direct Cable Connection cable), it will NOT work.
• Check to make sure your printer is on line.
• When using one computer to four printers, make sure the software
is installed correctly. If in doubt, simply reinstall the software as
described above.
• Make sure that you are using the correct printer driver. If you are, try
downloading the latest Raster or output-only printer driver from your
printer manufacturer's website.
Problem: I have an old tractor-feed printer which is running under DOS.
When I print, it does not eject an entire page.
Solution:
• This is valid only if you are sharing two computers and one printer you
must enable “Form Feed.” See page 3. The reason why your printer is
doing this is not because of the AutoSwitch, but rather the nature of the
DOS operating system.
Problem: I installed the AutoSwitch software, but now I want to remove it.
Solution:
• Click “Start”, click “Programs”, select “AutoSwitch”, then click
“Uninstall”. Follow the directions. Once you have rebooted your
computer, the printers will be attached to port LPT1.
Problem: I am getting spooling errors and time-out errors whenever I
select and attempt to print to a printer.
Solution:
• Save, exit out of all programs and restart Windows ® .
P73074/F1U119/AM/man.qxd 4/19/00 4:25 PM Page 18