Blue Rhino GWU501E - Manual (Page 14)

Replacing Pilot and Control Valve Series GWU501E, GWU511A, GWU512A LP Gas 606030 14
For assistance call 1.800.762.1142.
Step 12
Clean the pilot:
A. Place the #10 mm open ended wrench on the black hex tube and the #12 mm open ended wrench on the pilot orifice (this is the
brass piece on the bottom of the pilot housing).
B. Disconnect the orifice from the pilot housing.
C. Insert the pipe cleaner into the bottom of the pilot housing and slide through the top of the pilot hood.
D. Use the pipe cleaner to clean the the port that heats the thermocouple.
E. Use the soft bristle brush (or tooth brush) to clean the top of the pilot orifice.
F. Use the compressed air to remove any loose debris.