Binatone 2300 - Manual (Page 23)

Binatone Help Line : 0845 345 9677 21
Using a multi-handset system
Receiving an intercom call from a cordless handset.
When the phone rings and the display shows "HS 1 CALLING", you can answer
the call by pressing the SPEAKERPHONE button or picking up the handset.
If you want to end the intercom, press the SPEAKERPHONE button or
replace the handset.
During a call, it is possible to transfer a call to another handset.
To Make Intercom calls
To Transfer intercom call
Press the INTERCOM button. If you have only one cordless handset registered
to the base, the display will show "CALLING HS1" and the base will beep.
If you have more than one handset registered to the base, the display will
show "HS?" with the registered handset numbers above, and the base will
output a continuous beep, until you press the number for the handset you
want to intercom. Then the display will change, for example, to "CALLING HS2",
if it is handset 2 that is being called.
If you enter a number that is not available the base will return to idle mode.
The handset being called will ring with its selected melody and display
" BASE CALLING".
If you do not enter any number for 1 minute the handset will return to idle mode.
To cancel the intercom call press the INTERCOM button again.
During an external call, if you want to transfer the call to a cordless handset,
press the
INTERCOM button. The external call will be put on hold.
If the base has only one cordless handset registered it will immediately start calling
that handset, but if more than one handset is registered enter the number for the
handset you want to transfer the call to.
When the handset answers the intercom call, simply hang-up at the base to
transfer the call.
[1][2]…