Liebherr WKEes 553 GrandCru - Manual (Page 5)

11
Audible warning signal
The audible warning signal helps to protect your wines against
excessive temperatures.
It sounds when the door has
been left open for longer than
60 seconds.
It sounds when the interior gets
too warm or too cold. The tem-
perature display will also flash.
The symbol lights up.
The audible warning device is switched off by pressing the Alarm
button.
The temperature display will continue to flash until the cause of
the alarm has been rectified.
5 2 3 6 1 4
Interior light
The interior of the appliance is lit
by an LED light strip at the top of
the interior container.
The interior light will always switch
on when the appliance door is
opened.
Press the Light button if you want the interior light to be on even
when the door is closed.
The symbol lights up when the light is switched on.
The light intensity of the LED light corresponds to laser
class 1/1M.
Important
The light cover may only be removed by customer service
staff. If the cover is removed, do not look directly at the
light through optical lenses from close distance. This can
damage your eyes.
Furthermore, the brightness of the lighting can be adjusted.
Press and hold the Light button and at the same time press the
temperature setting buttons to increase or decrease the brightness.
Down = darker , Up = brighter
Fan switch
Thereby a climate which corresponds to that of a wine cellar is
achieved inside the appliance. Corks are prevented from drying
out due to an increased level of humidity.
Switching on: Press the Ven-
tilation button. The symbol
will light up.
Switching off: Press the Ven-
tilation button again. The
symbol will go out.
Setting the temperature
To reduce the temperature
Press the Down button.
To increase the temperature
Press the Up button.
- While you are entering the tem-
perature, the set temperature
will flash on the display.
- You can change the settings in increments of 1°C briefly pressing
the button again.
- The electronic controls will switch over automatically about 5 sec-
onds after the last time you pressed the button, and the actual
temperature will be displayed.
The temperature can be set at between +5°C and +20°C.
GB
8 7
bl 9
Operating and control elements
The electronic control panel has the new "touch capacitance
technology". Any function can be activated by touching the cor-
responding icon.
The exact contact point
is between the symbol and its label
Switching the appliance on an off
Switching on: Press the On/Off button
so that the temperature display lights
up/flashes.
Switching off: Press the On/Off but-
ton for approx. 3 seconds so that the
temperature display goes out.
Operating elements
 Appliance ON/OFF
 Temperature setting buttons
 Interior light ON/OFF
 Mute alarm
 Fan ON/OFF
 Temperature display
Control elements
 Interior light ON symbol
 Alarm symbol
 Child lock activated symbol
 Fan ON symbol