Liebherr WKEes 553 GrandCru - Manual (Page 6)

12
Air exchange with activated charcoal filter
The way in which wines continue to mature depends on the ambient
conditions. The quality of the air is therefore decisive for preserv-
ing the wine. We recommend that you replace the illustrated filter
once a year. Filters can be obtained from your dealer.
Changing the filter:
Take the filter by the handle.
Turn it 90° to the left or right and
remove.
Inserting the filter:
Insert with the handle in a verti-
cal position. Turn it 90° to the left
or right until it clicks into place.
Storing wine
If you are storing wine for long periods of time, it should be stored
at a temperature of between 10°C and 14°C.
This is the temperature wine cellars are kept at, and it is just right
to allow wine to mature properly.
The following drinking temperatures are recommended for the
various types of wine.
Red wines: +14°C to +18°C
Rosé wines: +10°C to +12°C
White wines: +8°C to +12°C
Sparkling wines, Prosecco: +7°C to +9°C
Champagne: +5°C to +7°C
Storage diagram
(for 750 ml Bordeaux bottles)
Total: 18 bottles
Setup mode
The following functions can be activated in setup mode:
= child lock, = display brightness
= Child lock
The child lock is designed to protect the appliance from being
switched off accidentally.
Activating the child lock
• Activate setup mode by pressing the
button for 5 seconds.
- The display reads .
• Press the button.
- The display reads .
• Press the button again.
- The symbol will light up to indicate that the child lock is acti-
vated.
• Exit setup mode by pressing the button.
Deactivating the child lock
• Activate setup mode by pressing the
button for 5 seconds.
- The display reads .
• Press the button.
- The display reads .
• Press the button again.
- The symbol will go out, indicating that the child lock is deac-
tivated.
• Exit setup mode by pressing the button.
= Display brightness
Adjusting the display brightness
• Activate setup mode by pressing the
button for 5 seconds.
• Press the button until appears in the display.
Press the button.
- The display reads 5 .
• Press the buttons and set the brightness between
0
= minimum and
5
= maximum.
• When you reach the desired level, press the button.
• Exit setup mode by pressing the button.
• Close the door. The new setting will activate after about 1 minute.
When commissioning the appliance, the adjusted brightness will
only be active once the set interior temperature of the appliance
has been reached.