Liebherr WTEes 2053 Vinidor - Manual (Page 6)

u Detach the transit
support of the door
Fig. 13 (20) .
u Do not dispose of the
transit support of the
door.
u Unscrew the lower
bearing bracket
Fig. 13 (17) .
u Screw the bottom turn
hinge Fig. 13 (17)
firmly into place on the
opposite side, using
the third and sixth
oblong hole counted
from the outside(with
4 Nm).
Fig. 13
If the appliance is transported again, the transit support has
to be re-fitted:
u Screw down transit support of the door Fig. 13 (20) at the
opposite side.
u Turn the top turn hinge
Fig. 14 (9) through 180° and
screw it firmly into place on
the opposite side with the
screw Fig. 14 (15) (with
4 Nm). Butt the turn hinge
against the side wall of the
appliance.
Fig. 14
4.3.3 Re-fitting the door and soft stop mecha-
nism
CAUTION
Danger of injury due to the spring tension acting on the soft
stop mechanism.
u Secure the soft stop mechanism.
u Angle the soft stop mecha-
nism Fig. 15 (5) in such a way
that the screw Fig. 15 (12)
can be screwed in. Firmly
tighten the screw (with
4 Nm).
Fig. 15
u Then angle the soft stop mecha-
nism in such a way that the front
screw Fig. 16 (10) can be
screwed in. Firmly tighten the
screw (with 4 Nm).
u Carefully lay the soft stop
mechanism Fig. 7 (5) on the
front face of the appliance.
Fig. 16
u At the bottom, place the
door on the bearing pin
Fig. 17 (16) .
Fig. 17
Fig. 18
u At the top, move the door over the turn hinge Fig. 18 (9) and
insert the Fig. 18 (18) bearing pin.
u Re-engage the cover of the turn hinge Fig. 5 (8) .
u Transfer the ball stud Fig. 4 (6) and tighten it firmly (with
2 Nm).
u Engage the soft stop mechanism with the ball journal.
u Attach the cover Fig. 3 (4) of the soft stop mechanism and
slide it forwards.
u Screw the stop Fig. 19 (13)
firmly into place, through the
white slide Fig. 19 (23) ,
using the screw Fig. 19 (14)
(with 4 Nm).
u Re-fit all the cover parts and
stoppers at the opposite
side.
Fig. 19
WARNING
Risk of injury due to the door dropping out!
If the bearing parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What
is more, the door may not close and therefore the appliance
may fail to cool properly.
u Screw on the bearing parts tightly as stated in the text.
u Check all of the screws and retighten if necessary.
4.4 Fitting
All the fasteners accompany the appliance.
Fig. 20
Fig. 21
Ensure that the following tools are to hand:
q Crosstip screwdriver
q Torx screwdriver 10
Putting into operation
6