4adjusting the contact of the door seal, Putting into operation, 4 adjusting the contact of the door seal – Liebherr UIK 1550 Premium User Manual
Page 8
u
Drill pilot holes in the door of the unit (possibly make prelimi-
nary holes with a bradawl).
u
Screw the appliance door to the unit door with screws
Fig. 16 (19)
passed through the mounting brackets
Fig. 16 (22)
.
Fig. 17
u
To adjust the depth of the unit door (Z): Undo the screws
Fig. 17 (15)
at the top and screws
Fig. 18 (24)
at the bottom,
then move the door.
u
Do not allow knobs and sealing lips
to make contact - important for func-
tion!
u
Allow an air gap of 2 mm between
the unit door and the body of the
unit.
Fig. 18
u
Check the fit of the door and readjust if necessary.
u
Tighten all screws.
u
Tighten the locknuts
Fig. 18 (10)
with the ring spanner
Fig. 18 (21)
, while holding the adjusting bolts
Fig. 18 (13)
with a screwdriver.
u
Attach top cover
Fig. 19 (26)
and snap into place.
Fig. 19
Check the following points to ensure the appliance is fitted
properly. Failure to do so may lead to icing, condensate
forming and malfunction:
w
The door has to close properly
w
The unit door must not butt against the unit body
4.4 Adjusting the contact of the door
seal
It may be necessary to adjust the appliance door, depending
on the weight of the kitchen unit door.
Once the kitchen unit door has been fitted, see that the door
seal makes full contact with the appliance body.
Fig. 20
The means for adjustment is situated on the right and left
underneath the bottle rack on the door interior.
The setting as delivered is 0.
The following adjustments are possible:
q
Inclination ± 1°
q
Upward adjustment by 4 mm
q
Downward adjustment by 2 mm
q
Adjustment by 2 mm to the left and right, respectively
NOTICE
Functional impairment and risk of damage!
u
Use the adjustment of the appliance door only for ensuring
that the door seal of the pull-out compartment makes 100
percent contact with the appliance body. Do not use it for
adjusting the kitchen unit door.
A check can be made on tight door closure by placing a shining
electric torch inside.
Putting into operation
8
* Depending on model and options