B&B Electronics Elinx EIR510-2SC-T - Manual (Page 95)

Manual Documentation Number: EIR510-xSFP-T_0708m 87
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
[NOTE]
1. When X-Ring function is enabled, disable the RSTP function. X-Ring
and RSTP cannot exist at the same time.
2. If the configuration is not saved, it will be lost when the switch is powered
down.
„ Security
In this section, you can configure 802.1x and MAC address table.
802.1X/Radius Configuration
802.1x is an IEEE authentication specification that allows a client to connect
to a wireless access point or wired switch but prevents the client from
gaining access to the Internet until it proves authority by providing a user
name and password, which is verified by a separate server.
System Configuration
1. IEEE 802.1x Protocol: Enable or disable 802.1x protocol.
2. Radius Server IP: Enter the Radius Server IP address.
3. Server Port: Enter the UDP destination port for authentication requests
to the Radius Server.
4. Accounting Port: Enter the UDP destination port for accounting
requests to the Radius Server.
5. Shared Key: Enter an encryption key for use during authentication
sessions. This key must match the encryption key used on the Radius
Server.
6. NAS, Identifier: Enter the identifier of the radius client.
7. Click Apply .